Buy B DANFOSS REFRIGERATION EKC D1, ller, I-pack the best price, fast worldwide shipping, up to 65% discount DANFOSS. EKC controllers can be used for a wide range of different refrigeration applications .. Regolatore per il controllo della temperatura – EKC D1, Literature. I need some help on this danfoss EKC D1. Its controlling a small freezer unit The set-point temperature is º The R1 seting is diferential is.

Author: Goltit Mogami
Country: Azerbaijan
Language: English (Spanish)
Genre: Art
Published (Last): 22 July 2018
Pages: 470
PDF File Size: 18.87 Mb
ePub File Size: 10.19 Mb
ISBN: 391-3-28094-182-4
Downloads: 6188
Price: Free* [*Free Regsitration Required]
Uploader: Nakree

Electronic Controls: Evaporator Controls with Thermostatic Expansion Valves

When the input is open it signals that the door is open. The battery module is used in conjunction with the real-time clock and will keep the clock going during lengthy power failures. Go to About section Our Engineering. Only the function belonging to the selected application is shown.

Here the signal may be used by the defrost function, so that the shortest and most energy-saving defrost can take place. Selection of thermostat sensor Here you define the sensor the thermostat is to use for its control function. Here a combination of S3 and S4 is used. Fan delay — water attaches to the evaporator 15 S Coordinated defrost There are two ways in which coordinated defrost can be arranged.


Alarm will be given when the input is opened. Controller tray for refrigeration appliance control with TEV.

EKC – Documents

This timer function can be used as a simple way of starting defrosts, but it will always act as safety defrost if one of the subsequent defrost starts is not emc. Temperature difference for night time cover When the night time cover is placed over the appliance, the difference between the S3 and 2021d sensors will fall due to the reduced cooling loss.

The relay cuts in when rail heat is to operate Light: Defrost start can also be accomplished via data communication, via contact signals or manual start-up. Retrofit and High Glide Refrigerants.

When the night time cover is placed over the appliance, heat intake and thus the need for increased cooling are reduced. Stop Temp Interval between defrost starts The function is zeroset and will start the timer function at each defrost start.

When all t01 to t16 equal 0 the clock will not start defrosts. This function requires the use of both an S3 and S4 sensor. Kec function is defined in o02 or in o The function is defined in o37 Definition of alarm sensor Both S3 and S4, or a combination of both units, can be used as an alarm sensor. Sensors S3 and S4 are thermostat sensors. Refrigeration 10 6 A DO2.


Product Range 3 Documents Visuals 2. Here the temperature reference is changed easily with a contact signal on a digital input. Low temperature alarm for S3 S3 Low temp A When the value is passed, a defrost will start.

Electronic Controls: Evaporator Controls with Thermostatic Expansion Valves – Documents

But you can also use a sensor with another signal accuracy. Regulator til temperaturstyring – EKC D1. S4 air temp Ther. Refrigeration control with one compressor The functions are adapted to small refrigeration systems which either may be refrigeration appliances or cold rooms.

The evaporator drips off and waits for the time to run out 4 S Regolatore per il controllo della temperatura – EKC D1. The value is the same as the one set for night setback, but will only be raised if the value is positive. The individual status codes have the following meanings: When there is an alarm all the light-emitting diodes LED will flash on the controller front panel, and the 202f1 relay will cut in.